你现在的位置:首页>企业动态

双组份打胶机在操作时的注意事项

浏览:0
在制作中空玻璃的整个过程中,对中空玻璃的密封是关重要的,研发了各种辅助设备,如济南双组份打胶机,下面就来讲讲它在操作时的注意事项。
In the whole process of making insulating glass, the sealing of insulating glass is very important. Various auxiliary equipment have been developed, such as Jinan two-component glue applicator. Here are the precautions for its operation.
1、液压站系统的压力,不能调的太高,要根据室内环境温度等实际情况,调满足胶嘴正常出胶均匀打胶即可。打开液压站时一定要打开胶枪,否则B组份管路压力将升得很高,造成事故。
1. The pressure of the hydraulic station system cannot be adjusted too high. According to the actual situation of indoor ambient temperature, adjust it to meet the normal glue output of the glue nozzle and apply glue evenly. When opening the hydraulic station, be sure to open the glue gun, otherwise the pressure of component B pipeline will rise very high, causing safety accidents.
2、若涂胶工作过程中停顿时间超过15分钟以上时,一定要用“冲枪”。本机有报警功能,到时没有冲胶会有蜂鸣器报警。
2. If the pause time in the gluing process is more than 15 minutes, be sure to use the "punching gun". This machine has an alarm function. If there is no glue flushing at that time, there will be a buzzer alarm.
3、A胶提胶泵连续工作1分钟以上没有供胶停止,说明管路内有空气,此时会报警,须打开泵上管接头再打开A胶提胶泵,直到出胶为止,停止并接好接头,胶枪会出现有空气的哔哔爆破声,空气排净就好了。
3. A glue lifting pump works continuously for more than 1 minute without stopping the glue supply, which indicates that there is air in the pipeline. At this time, an alarm will be given. You must open the pipe joint on the pump and then open a glue lifting pump until the glue is discharged. Stop and connect the joint. The glue gun will have a beep explosion sound of air, and the air will be discharged.
4、由于每次冲洗混合器不会完全干净,每次都有少量的混合胶沉积,越来越多,以致堵塞混合器通道,用一段时间后,影响出胶量和混合效果,因此要定期(聚硫胶五天,硅酮胶两天)清洗混合器。把混合器内的混胶棒拆出,如有损坏更换新的混胶棒。若混胶棒拆不出来,可用火烧掉,注意不能损伤零件螺纹。
4. Since the mixer will not be completely clean after each flushing, a small amount of mixed glue will be deposited every time, and more and more will block the mixer channel. After a period of time, the glue output and mixing effect will be affected. Therefore, the mixer should be cleaned regularly (polysulfide glue for five days, silicone glue for two days). Remove the glue mixing rod in the mixer, and replace it with a new one if it is damaged. If the glue mixing rod cannot be removed, it can be burned with fire, and pay attention not to damage the thread of the part.
5、B胶桶内如果要有空气,空气将排不出来,B泵将快速往返运动,不能向高压泵内正常供胶,影响整个系统,因此,必须将空气排出来。方法是:将压盘提出从新压入并放气。
5. If there is air in the rubber barrel B, the air will not be discharged, and the pump B will move back and forth quickly. It cannot supply glue to the high-pressure pump normally, affecting the whole system. Therefore, the air must be discharged. The method is: lift the pressure plate, press it in again and bleed.
济南双组份打胶机
6、压盘上的放气阀门要保持通畅,要定期疏通和清洗。
6. The vent valve on the pressure plate should be kept unobstructed and regularly dredged and cleaned.
7、硅酮胶B组份遇空气会结壳,影响泵的正常工作和管路的畅通,因此,停机时B组份胶的所有通道在泄压后均应关闭,使B组份不得接触空气。
7. Component B of silicone rubber will crust when encountering air, which will affect the normal operation of the pump and the smoothness of the pipeline. Therefore, all channels of component B rubber should be closed after pressure relief during shutdown, so that component B cannot contact the air.
8、定期检查气源,应保证使用经干燥的洁净压缩空气,并定期排放分离过滤器中的积水,检查油雾器中的油是否够用。
8. Check the air source regularly. First of all, ensure the use of dry clean compressed air, and regularly discharge the accumulated water in the separation filter, and check whether the oil in the oil mist is sufficient.
9、正常工作时不要断气源,如果发现断气源应停止工作。
9. Do not cut off the air source during normal operation. If the air source is found to be cut off, stop working.
双组份打胶机具有性、低成本、产量高等优点,能够在大幅提供企业产量的同时也会降低企业的运营成本,其中既包含人力成本也包含物料成本,所以在使用前要充分了解,更多是想就来我们网站http://www.jntiannuo.com咨询吧。
The two-component glue applicator has the advantages of high efficiency, low cost and high output. It can not only greatly provide the output of the enterprise, but also reduce the operation cost of the enterprise, which includes both labor cost and material cost. Therefore, you should fully understand it before using it, and come to our website if you want to http://www.jntiannuo.com Consult.

上一篇:点胶机操作流程以及维护保养事项
下一篇:打胶机使用期间容易出现这样的问题

  • 微信