你现在的位置:首页>企业动态

教你灌胶机的保养方法!

浏览:0
灌胶机的保养方法是怎么做的
  How to maintain the glue machine
  1、清洁灌胶设备表面的灰尘以及AB胶的污渍;
  1. Clean the dust on the surface of glue-filling equipment and the stain of AB glue;
  2、检查润滑系统是否正常;
  2. Check whether the lubrication system is normal.
  3、检查机器、工作台、导轨以及主要滑动面是否可以支持正常运作;
  3. Check whether machines, workbenches, guideways and main sliding surfaces can support normal operation.
  4、检查灌胶机的各类设置是否正常;
  4. Check whether all kinds of safety settings of glue filling machine are normal.
  5、检查机器是否有异常声音;
  5. Check whether the machine has abnormal sound.
  6、电源开关、启动开关等是否灵活,XYZ轴是否准确、可靠停止。
双组份打胶机
  6. Whether the power switch and start switch are flexible, and whether the XYZ axis is accurate and reliable to stop.
  7、检查灌胶机的工作台、导轨及主要滑动面有无新的拉、研、碰伤等,如有情况,需立即报告相关人员查看,并做好记录。
  7. Check whether there are any new pull, research and bump on the worktable, guide rail and main sliding surface of the glue filling machine. If there is any situation, it is necessary to report to the relevant personnel immediately for inspection and record.
  自动点胶机的驱动机构
  Driving mechanism of automatic dispensing machine
  自动点胶机的驱动机构主要分为四种,主要包括:液压驱动、气压驱动、电气驱动以及机械驱动。
  The driving mechanism of automatic dispensing machine is mainly divided into four kinds, including hydraulic drive, pneumatic drive, electrical drive and mechanical drive.
  但是绝大部分的点胶机都会采用电气、气动驱动,因为自动点胶机设备采用这两种驱动系统可以更好地节省用胶,使得胶水资源能够合理利用,降低了不少点胶成本!
  But most dispensing machines will use electric and pneumatic drive, because the automatic dispensing machine equipment using these two drive systems can better save the use of glue, make the rational use of glue water resources, reduce a lot of dispensing costs!

上一篇:介绍中空玻璃打胶机怎么操作!
下一篇:传感器为什么使用双液点胶机设备?

  • 微信