双组份打胶机在使用中应该怎样维护
1.由于双组份打胶机密封胶的固化需要一定时间,因此,已涂了双组份打胶机密封胶的玻璃应水平轻轻搬动.
1. Due to the two-component glue confidential sealing glue curing need for a certain period of time, therefore, has painted two copies of glue confidential sealing glue glass should horizontal to gently move.
2.双组份打胶机的A组、B组份胶应保持清洁,严防异物进入胶中.
The 2 two-component atx-ii A group, B group portion of the glue should be kept clean, to prevent the foreign body into the glue.
3.在连续工作过程中,胶枪每次停止工作时间一般不得超过20分钟,否则,应用A组份胶冲出全部混合胶,直单一的A组份胶从枪口排出为止.
3 in the process of continuous work, the glue gun to stop working time is generally not more than 20 minutes, otherwise, the application of A group of plastic out of all the mixed rubber, until a single A group of rubber from the muzzle.
4.双组份打胶机的高压胶管不得强行挤压、弯曲,防止影响系统正常工作.
4 pairs of sets of plastic machine of the high pressure hose shall not force the extrusion, bending, to prevent the impact of the system to work normally.
5.混胶器应经常保持畅通,以保证良好的出胶效果.如遇堵塞情况,可用丙酮浸泡后清洗.建议每5组清洗一次.
5 the rubber mixing machine should always keep the flow, in order to ensure the good result. If the case of the case of the plug, can be cleaned with acetone. It is recommended that every 5 groups be cleaned once.
6.当的胶枪长时间不用时(超过一周),应拆下枪体使用溶剂将胶枪和混胶器内的残留胶体清洗干净.
6 when the glue gun is not used for a long time (more than a week), the body of the gun should be removed and the residual colloid in the glue gun and the mixture is cleaned.
7.不同双组份胶生产厂家所生产的胶内含杂质数量不同,根据实际情况清晰B组分的过滤网及单向止回阀,建议每两组清洗一次
7 different pairs of rubber production factory produced by the number of different impurities, according to the actual situation of clear B component of the filter and check valve, recommended every two groups of cleaning
8.定期给各泵的加油口加油,应保证油雾器内不断油.
8 regularly to the pump of the oil gas, should ensure that the oil mist device continuously.
了解了双组份打胶机的日常维护要点后,相信您也懂得了应该怎么来维护您的双组份打胶机了吧.
Understanding of the two groups of parts of the machine after the maintenance of the daily maintenance, I believe you also know how to maintain your double set of plastic machine.
上一篇：中空玻璃设备的强度和硬度是如何进行分别的？
下一篇：旋转轴自动点胶可以提升圆形点胶效果吗？
